Posted 09 June 2012 - 06:33 PM
I was doing a firmware update and lost power (yes, I know I should have had it plugged in!). Since then the caanoo won't power up or show any sign of life except the charging light comes on if I plug it in. I have looked all around this forum and the Internet in general and I can't find a solution. I tried to contact the service centre in Germany but they seem to have gone along with GPH support.
If anyone can save me and my Caanoo I would be very grateful.
Posted 09 June 2012 - 09:27 PM
Posted 16 June 2012 - 07:02 PM
Posted 19 July 2012 - 05:16 AM
Posted 20 July 2012 - 08:16 PM
Thanks but I already tried standard SD as well, it seems the boot loader is gone.
This may be worthless info but, I had thought I bricked my wiz a while back only to find out that it was because I was using an SDHC card. It was unable to boot but I managed to flash it anyways on a standard SD and it was as good as new. Firmware upgrades don't like SDHC.
Posted 07 April 2013 - 05:30 PM
Sorry to post in an old thread but I haven't seen any news.
I just thought I would check back to see if anyone had any updates (Orkie?) I looked at the Unbrick Your Wiz pdf but the hardware side of it is not something I am up to I don't think. If I knew for sure that it would work with the caanoo then I would risk butchering my TVout cable (I can't use the caanoo one because I don't have a spare) but I am far from confident in my soldering skills.
Edited by Hamish The PolarBear, 07 April 2013 - 05:50 PM.